Warning – Daystar KJ09155BK-1 User Manual
Page 4
KJ09126 1997-2006 Jeep TJ/LJ Rock Krusher
3” Coil Spring Spacer Lift Kit with shocks
Instruction Sheet P10862-00
2008 Daystar Products International Inc
.
www.DaystarWeb.com
Tech Support Contact Info
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
Rear Track Bar Bracket Installation
NOTE: It is easiest to perform this installation once the rear disassembly steps are
completed.
1. Unbolt the rear track bar at the axle. Save the hardware for re-use.
2. Position the rear track bar bracket over the axle bracket as shown. Install the
supplied 7/16” bolt through the bracket and the original track bar mounting hole.
3. Using the bracket as a template, mark and drill the location of the ½” hole in the
side of the factory track bar bracket.
4. Remove the 7/16” bolt and install the supplied ½” bolt, washer, and nut in the
hole just drilled. Tighten to 57 lb-ft.
5. Re-install the 7/16” bolt along with the supplied spacer as shown through the
track bar mounting hole. Tighten to 37 lb-ft.
6. Once the springs and spacers are in place, line up the track bar with the
bracket’s upper mounting hole and secure it using the factory hardware. Tighten
to factory specifications.
WARNING
This vehicle has been modified to enhance its performance.
The steering, braking and handling of this vehicle will differ
from standard passenger cars and trucks; this vehicle handles
differently from an ordinary vehicle in driving conditions which
may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp
turns and other driving conditions that could cause loss of
control, possibly leading to a roll over or other accident that
could result in serious injury or death to driver and passengers.
If larger tires are installed the speedometer will read lower
than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED
AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic.