Daystar KJ09155BK-1 - Manual

KJ09126 1997-2006 Jeep TJ/LJ Rock Krusher
3” Coil Spring Spacer Lift Kit with shocks
Instruction Sheet P10862-00
 2008 Daystar Products International Inc .
www.DaystarWeb.com
Tech Support Contact Info
[email protected]
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
st
Avenue
Phoenix, AZ 85043
DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT
Step(s)
TRANSFER CASE DROP INSTRUCTIONS
1. Place a floor jack under the transfer
case cover. Remove all bolts from one
side of the cover, lower the jack and put
supplied polyurethane spacers and steel
sleeves between the cover and the
frame. (supplied are 1/2-13 for 1997-
2003 TJs and M12X1.75 bolts for 2004-
newer jeeps)
LIFT INSTRUCTIONS
2. Layout all parts and check quantities
against the Bill of Materials. Completely
read instructions before beginning
installation.
3. Make sure you are working on a level,
stable concrete surface or using a lift to
perform this work.
4. Either using a lift or floor jacks, lift the
front of the jeep to full droop (where
wheels are just off the ground). If a floor
jack is used, transfer the vehicle to jack
stands. Pull front wheels.
5. Place two floor jacks under the front axle and load (lift) the suspension 2”.
6. Pull shocks off, disconnect sway bar end links and unbolt the track bar. (Fig. 2, 3)
7. Lower the suspension to full droop again.
Tools required
Description: Qty.
Standard Hand Tools 1
Wrench Set & Socket Set 1
Coil Spring Compressor 1
Drill + 5/16-11/32 Bit 1
Floor Jacks / Jack Stands 2 per
Bill of Materials
Part No. Description Qty.
M03606 PU,COIL SPRING SPACER 2
M03520 PU,BUMP STOP W/BOLT INSERT 4
M02878 PU,COIL SPRING SPACER 2
S10922 BRACKET, TRACKBAR, REAR 1
BJ09126-B BAG KIT,SUSP LIFT, 3",JEEPTJ 1
BJ09126-A
BAG KIT,SUSP LIFT, 3",JEEPTJ
(TRANSFERCASE DROP HARDWARE)
1