Daystar KT09131-1 - Manual (Page 4)

7. Put thread lock on the 8 ( S11105) stud extenders and using a 5/8 wrench in-
stall them on the strut, then install the strut spacer( M03800) over the stud
extenders.
8. Install the strut assembly with the spacer installed back into the truck and put
the 4 upper strut nuts on to hold the strut from falling out.
9. Raise the lower control arm so that the lower strut bolt/nut can be installed.
Put thread lock on the 2 lower ball joint bolts.
10. Using a 24mm socket install the lower ball joint bolts into the control arm/
knuckle assembly and tighten.
11. Using a 5/8 wrench tighten the upper strut nuts. With a 22mm socket and
wrench tighten the lower strut bolt and nut.
12. Using a 24mm socket tighten the inner lower control arm bolts.
13. Reinstall the tires and tighten the lugs to 85 ft lbs. Jack up the truck and
remove the jack stands. Lower Jeep back to the ground .
14. With the truck on the ground install the sway bar end-link. Using a 19mm
socket tightened the bolt.
15. Check all bolts and nut that they are installed and tighten down.
16. Have a qualified wheel alignment center realign the front end to factory
specs.
17. Have the headlight adjusted to proper settings.
18. Wheels must be retighten at 50 miles.
19. All components must be retighten at 500 miles and then at 3000 miles.
20. Install “ Warning to driver” decal to sun visor.