Daystar KT09131-1 - Manual (Page 3)

Installation steps
1. The tools needed for installation are on the back cover. A list of parts in the kit are
under the tool listing. Make sure you have all of the proper tools and understand
these directions before proceeding.
2. Place the truck on a clean level surface and set the parking brake. Chock the rear
wheels and using a floor jack raise the front of the truck and support the truck with
approved jack stands under the frame rail behind the front wheels. NEVER
WORK UNDER AND UNSUPPORTED VEHICLE. Using a 21mm deep well
socket remove the front wheels.
3. Disconnect the front sway bar lower end links using a 19mm socket.
4. Loosen the two inner lower control arm
pivot bolt using
a 24 mm socket.
5. Place a floor jack under the lower control arm and support the arm, using a 14mm
socket remove the upper strut nuts. Using a 22mm socket and wrench remove the
lower strut bolt and nut.
6. Using a 24mm socket remove the lower ball joint
bolts and lower the control arm down, to remove the strut assembly.