Daystar KG09107 - Manual (Page 2)

3
Quantity Part Number Description
2 PT11428 Torsion Keys
2 P11412 Lower shock ex-
tenders
1 p11400 Instructions / Decal
Bill of Materials
Quantity Description
2 Frame Jack stands
1 Floor Jack
2 Wheel chocks
1 Torsion key Puller (see instruction Notes)
1 1/2” Ratchets set
1 1/2” Sockets
1 1/2” Short socket extension
1 Rubber Mallet
Tools Needed
Part List
4
IMPORTANT: The net amount of ride height increase de-
pends upon the age and use of the vehicle, wheel offset, and
numerous other factors. Stated torsion bar ride height increas-
es are based upon factory specifications. If the torsion bars
were “cranked up” at some point in the past, expect a corre-
sponding reduction in overall height increase with the new tor-
sion keys. Note that torsion bars, like any other spring, are
subject to fatigue and sagging over time. Also, torsion bars
have different ratings depending on how the vehicle was
equipped from the factory. In some cases, installing heavier
rated bars (which can be purchased from a dealer) may be the
only solution to regaining ride height lost from adding heavy
** NOTICE **
Before install of this kit. #KG09107
Check color marked on factory Torsion bar key.
(color will be marked with paint on side of torsion
key) This kit is for keys marked with the fallow-
ing colors. PURPLE, BLUE, and YELLOW.
You can check also check with your local dealers
service and parts department for correct infor-
mation.
!Warning: Always work with appropriate personal safety
gear including safety glasses, gloves and hearing protection if
using air powered tools.
Begin by inspecting the components & hardware for damage.
Then compare components & hardware to the bill of materials for
completeness. If anything is missing/damaged, do not proceed
with the installation. Please, call Daystar Products (800-595-
7659) and we will send you the missing of damaged components
free of charge.
!Caution: Vehicle front end must be raised to install leveling
kit. Using a hydraulic chassis lift will greatly ease installation.
If another jack is used, assure vehicle is level on a firm sur-
face, in park (1st gear), rear wheels blocked and jack stands