Daystar KJ71042BK - Manual (Page 4)

7
10. Deburr the holes drilled in the steps 8 & 9 and use some touch up paint on
bear metal edges to prevent corrosion.
11. Once the paint is dry install the supplied grommets into each of the
three (3) vent holes.
Install grommets
12. Open the hood and rest it on the factory hood prop.
13. Locate the following components: 4 x flat washers, 2 x 3/16” long
bolts, 2 x 1” long bolts, 1 x Extractor Hood Vent, 1x bolt wedge.
14. Place a flat washer on each bolt
15. Starting with the 3/16” long bolts, secure the Daystar hood vent to
the hood.
Notice: Leave the bolts loose, so there is some play in hood vent
This will make locating the remaining mounting bolts easier.
Under side of hood
8
17. Once all four (4) of the mounting bolts are located, tighten them.
16. Move onto the 1” long bolts along with the bolt wedge. Match the
curved side of the bolt wedge to the curve of the hood. It may be
necessary to wiggle the Hood Vent in order to align all of the mount-
Under side of hood
Hood outer edge