Daystar KJ71042BK User Manual
Page 3
5
5. With the painter’s tape affix the template to the Jeep.
Notice: Before any holes are drilled make sure the template is located
on the hood correctly. If you are unsure please, do not hesitate to con
tact Daystar’s technical department 800-595-7659.
6. Using a center punch and hammer locate the centers of the four (4)
mounting holes and the three (3) vent holes.
Notice: Do not strike the center punch with too much force, or dam
age to the hood will occur.
7. Use caution when drilling holes. Make sure there is not any items under
the hood that will be damaged. It is a good idea to prop the hood up at a
workable angle to provide additional under hood clearance during the
drilling steps.
6
8. Starting with the 3/16” drill bit drill the four (4) mounting holes.
Notice: When drilling the two (2) mounting holes located on the outside
curvature of the hood. Start with the drill perpen- dicular to the
hood. Once, the drill is through the hood rotate the drill up 90 degrees
9. Change over to the 1-1/4” hole saw and cut out the three (3) vent holes.
Apply paint to
bear metal edges