Daystar KF09124BK - Manual (Page 2)

3
Tools Needed
Part List
Bill of Materials
Part No. Description Qty
M20151 Front Spacer 2
S20150 Stud extenders 6
S10010 10mm Washer 6
S10292 10mm –1.5 lock nut 6
P11153 Thread lock / Decal 1
Description Qty
Pry Bar 1
Floor Jack 1
Jack Stands / Wheel chocks 2
Lug Wrench 1
10mm wrench 1
17mm wrench 1
20mm wrench 1
21mm wrench 1
Torque wrench 1
IMPORTANT NOTICE : The advertised amount of lift that this kit
provides and the thickness of the spacers supplied will not be the same!
For example, a 2-1/2” lift may only have 1-1/2” thick spacers. The
reason for the difference between the spacer thickness and the amount
of lift has to do with suspension geometry. There is a ratio involved,
and it is this ratio that determines the thickness of the spacers. Rest
assured, installing the spacer supplied will result in the proper amount
4
Installation Instructions
!Warning: Always work with appropriate personal safety
gear including safety glasses, gloves and hearing protection if
using air powered tools.
Begin by inspecting the components & hardware for dam-
age. Then compare components & hardware to the bill of materi-
als for completeness. If anything is missing/damaged, do not pro-
ceed with the installation. Please, call Daystar Products (800-595-
7659) and we will send you the missing of damaged components
free of charge.
!Caution: Vehicle front end must be raised to install leveling
kit. Using a hydraulic chassis lift will greatly ease installation.
If another jack is used, assure vehicle is level on a firm sur-
face, in
park (1st
gear), rear
wheels
blocked and jack stands in place to support vehicle in case
jack or vehicle shifts.