Daystar KU70038BK-4 User Manual
Page 4
1. Lube the 2 poly bushing (
1
) then install them into the control
arm.(
2
)
2. Push the steel sleeve(
3
) into the bushings.
3. Install the S10818 1-14 jam nut (
4
) onto the rod assembly (
5
) .
4. Install the control arm assembly (
2
) onto the rod assembly (
5
).
5. Set the length of the arm to stock length if not lifted. If lifted add
a .250 to the length over 2.0” of lift. This is only a starting length.
You will need a wheel alignment to get the arms set to the right
length.
Control arm assembling steps
1
2
3
4
5
2
5
6.
Raise up the jeep and place floor jacks under the frame. Place
wheel chocks behind the rear wheels.
7.
Remove the wheels and place the jack under the front axel and
support it.
8.
With a 21mm wrench and socket remove the front lower control
(
4
) arm bolts (
3
).
Installation steps