Daystar KU70038BK-4 User Manual
Page 3
9.
Remove one control arm at a time
.(
1
)
10.
Install the Daystar lower control arm assembly with the bend to
the inside.
11.
Install the front and rear 9/16 bolt and nuts and washers. Finger
tighten the nuts.
1
Bend
Installation steps
Poly Flex joint assembly
1. Using a retaining clip pliers install the C-clip (
1
) into the Steel shell
(
4
) then place the washer (
2
) into the shell (
4
).
2. Put a small amount of poly-lube over the poly-flex bushing (
3
) then
install it over the steel washer (
2
)in the steel tube.(
4
)
3. Put a small amount of poly-lube over the steel ball (
5
) and then install it
in the steel tube (
4
) then install the other poly-flex bushing (
6
) over the
steel ball (
5
) .
4. Using the ploy-flex joint tool.( KU70091) Place the assembly (
2
)into
the large tool (
1
)and the place the washer (
3
) and C-clip (
4
)over opened
end off the assembly (
2
).
5. Place the small tool (
5
) over the washer (
3
) and push the 7/16 bolt (
6
)
through the assembly(
2
) and thread on the 7/16 nut.
6. With a 5/8 wrench and 5/8 ratchet on the bolt and nut tighten them down
so you can install the c-clip (
4
) using a c-clip pliers.
7. Repeat step's on the other threaded rod end.
1- S10617
2- S10135
3-M00492
4– ref
5-S10616
6-M00494
2
1
1
2
3
5
6
4