Daystar KU70038BK-1 User Manual
Page 3
8.
Install the Daystar lower control arm using the two 9/16 bolt
per arm. With the front bolts coming from the outside in and
the rear going inside out.
9.
Tighten the bolts to 75ft lbs.
10. Repeat step on other control arm.
11. You will need a wheel alignment to the control arm to the right
length.
Front Bolt
Rear bolt
Installation steps
Poly Flex joint assembly
1. Using a retaining clip pliers install the C-clip (
1
) into the Steel
shell (
4
) then place the washer (
2
) into the shell (
4
).
2. Put a small amount of poly-lube over the poly-flex bushing (
3
)
then install it over the steel washer (
2
)in the steel tube.(
4
)
3.
Put a small amount of poly-lube over the steel ball (
5
) and then in-
stall it in the steel tube (
4
) then install the other poly-flex bushing
(
6
) over the steel ball (
5
)
.
4. Using the poly-flex joint tool.( KU70091) Place the assembly (
2
)
into the large tool (
1
)and the place the washer (
3
) and C-clip (
4
)
over opened end off the assembly (
2
).
5. Place the small tool (
5
) over the washer (
3
) and push the 7/16 bolt
(
6
) threw the assembly(
2
) and thread on the 7/16 nut.
6. With a 5/8 wrench and 5/8 ratchet on the bolt and nut tighten them
down so you can install the c-clip (
4
) using a c-clip pliers.
7. Repeat step's on the other threaded rod end.
1- S10617
2- S10135
3-M00492
4– ref
5-S11085
6-M00494
2
1
1
2
3
5
6
4