Programming, Chapter 6 programming, Programming instructions using palm pilot – Grain Systems PNEG-1181 User Manual

Page 16

PNEG-1181 Portable Dryer Troubleshooting

6. Programming

Programming Instructions Using Palm Pilot

There are three (3) boards to program on the Network Dryer: Display Board (lower control box),
Input/Output Board (upper control box), and Heater Interface Board (by Fan/Can housing).

1. Turn the control power on the dryer to the OFF position.

2. Locate the programming jack on each individual board:

• Display Board (lower control panel) - (DB-9) located at bottom of board.

• Input/Output Board (upper panel) - (DB-9) located at bottom of board.

• Heater Interface Board (by fan/can housing) - (J2 connector) located on back of board.

NOTE: Refer to

See Figure 6A on Page 17

3. If programming the Input/Output Board or Display Board, connect the DB-9 connector from the

Palm Pilot to the board.

4. If programming the Heater Interface Board, connect the J2 connector on the series 2000 cable to

the J2 connector on the back of the board.

5. Unplug the network connection (yellow and blue wires) to the board being programmed.

6. On the Palm Pilot, select the program for that particular board and select it by “tapping” on it.

7. Turn the dryer control power back ON.

8. The programming process begins by erasing the present program and starting the new program.

9. The screen will display a confirmation screen when the transfer of the software is complete.

10. Turn the dryer control power OFF and remove the connector from the board. Plug the network wires

back into the board being programmed.

11. Turn ON the dryer and the opening screens on the dryer will indicate the latest version of software.

There are two Palm Pilot kits available from GSI for order:

Ref #

Part #

Description

D03-0692 (Palm Flash Program Kit Deluxe)

D01-1771

Series 2000 Programming Cable

D03-0688

Palm Pilot IIIC (color)

D03-0694

Palm Pilot Hot Sync Cable

D03-0695

Palm Flash 9 Pin M-M Adapter

D03-0709

Disk, CD-ROM Palm Flash Software

D03-0693 (Palm Flash Program Kit Economy)