Grain Systems PNEG-1702 - Manual (Page 11)

3. Decals
PNEG-1702 ETL Listed GSI/FFI Portable Dryer Manual 11
Déplacer des pièces
peut écraser et couper.
Gardez les mains
éloignées. Ne pas faire
fonctionner sans avoir
de gardes en place.
L’omission de faire ceci
pourra résulter à de
sérieuses blessures. Moving parts can crush
and cut. Keep hands
clear. Do not operate
without guards in place.
Failure to do so could
result in serious injury.
WARNING
AVERTISSEMENT
DC-1945
Rotating auger will
crush and cut. Auto
equipment can start
at anytime. Do not
enter until electric
power is locked in off
position. Failure to do
so will result in
serious injury or
death. La foreuse tournante
écrasera et coupera.
L’équipement
automatique peut se
mettre en marche en
tout temps. Ne pas
entrer tant que la
puissance
électrique ne soit
fermée à la position
‘arrêt’.
DC-1947
Automatically controlled
belt drive can start at
anytime. Keep hands
clear. Failure to do so
could result in serious
injury. La conduite
automatiquement
contrôlée de la courroie
peut démarrer à tout
moment. Gardez les
mains éloignées.
L’omission de faire ceci
pourra résulter à de
sérieuses blessures.
WARNING
AVERTISSEMENT
DC-1944
Decal: DC-1945
Decal DC-1945 is located on the bottom auger
belt guard and the front bearing plate (which is
visible when the bottom auger belt guard is
removed). An alternate location would be at the
rear of the dryer for portable dryers equipped
with the Front Discharge Option.
Decal: DC-1944
Decal DC-1944 is located on the bottom auger
belt guard and the front bearing plate (which is
visible when the bottom auger belt guard is
removed). An alternate location would be at the
rear of the dryer for portable dryers equipped with
the Front Discharge Option. Another location
for decal DC-1944 is on the top of the auger belt
guard (one on the belt guard cover and one on
the inside belt guard body visible when the belt
guard cover is removed).
Decal: DC-1947
Decal DC-1947 has several different locations.
Two (2) are located on the front end panel
below the fan/heater. Two (2) are located on
the rear end panel below the rear access door.
Two (2) are located on the auger discharge box
(one on the outside top and one on the inside of
the flapper lid next to the discharge mercury
switch). One more of these decals is located
inside the plenum on the rear plenum closure
door just inside the rear access door.