Inlet dump hopper assembly – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1128 User Manual
Page 36
6. Installation
36
PNEG-1128 Chain Loop System without Controls
Inlet Dump Hopper Assembly
The dump hopper will include a length of tubular conveyor from 6' to 11' depending on the length of dump
hopper selected. It will also include a top safety screen or drive over grating. There is a grain flow control
inside the hopper that is adjustable using chains mounted at each end. A dump hopper is to receive grain
into the Chain Loop System and should be located at a point along the bottom conveyor portion. Usually
dump hoppers are located near the standard corner where the chain and paddles turn to carry grain up.
For drive over systems, the grate must be supported by a concrete structure.
Figure 6S
A hopper with top safety screen may be used in non-drive over situations. The top safety screen will not
support vehicles. Make sure either the top safety screen or drive-over grating is in place on the hopper.
Fasten the inlet dump hopper assembly in place within the tubular conveyor with connecting bands.
Figure 6T
NOTE: When the system is not in use, it is a good practice to cover the hopper with a rubber mat to help
keep water, animals and debris out.
for
further detail