Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1128 - Manual (Page 25)

6. Installation
PNEG-1128 Chain Loop System without Controls 25
Chain Loop Torque Arm Repair Kit (Continued)
Attach the torque plate anchor bracket to the torque plates using the two (2) 1/2" flat washers, shoulder
bolt and 3/8"-16 nylock nut.
Tighten the hardware attaching the torque plate assemblies to the gear reducer after tightening the
shoulder bolt hardware.
(See Figure 6G.)
Figure 6G
Move the torque plate anchor bracket on the square tube so the torque plate assemblies are aligned
vertical. Once aligned, the 3/8"-16 hardware attaching the torque plate anchor bracket to the C-clamp can
be tightened.
(See Figure 6H.)
NOTE: Washers must be on the outside of each torque plate assembly.
Figure 6H