Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1128 - Manual (Page 21)

6. Installation
PNEG-1128 Chain Loop System without Controls 21
Tube and Corner Assembly
Lay the sections out in order so as to determine what portions to assemble prior to actual placement in
the system.
When cutting tubes to exact length, the ends must be cut square and any burrs on the ends must be
removed by chamfering the inside diameter. Join tube and corner components together with connecting
bands. Slide the tube sections tight together and space the connecting band in equal amounts on both
parts of the connection. Tighten the bolts in the band.
Fasten the discharge in place within the tube with connecting bands.
Figure 6B