beautypg.com

Chain loop torque arm repair kit – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-1128 User Manual

Page 23

background image

6. Installation

PNEG-1128 Chain Loop System without Controls

23

Chain Loop Torque Arm Repair Kit

NOTE: Motor mount and belt guard removed for clarity.

Attach both torque plate assemblies to each side of the gear reducer using the bolts provided. Re-use the
lock washer and hex nut provided with the gear reducer.

(See Figure 6D.)

NOTE: Leave the hardware loose to allow for ease of assembly.

TA3 - 3/8"-16 Bolt
TA4 and TA5 - 1/2"-13 Bolt

Figure 6D

WARNING

Secure the motor mount from both sides to prevent the drive unit from pivoting
either direction on the shaft.

See also other documents in the category Grain Systems Equipment: