Grain Systems PNEG-1707 - Manual (Page 52)

10. Service
52 PNEG-1707 TM-Series Tower Dryer
Lubrication Table
Location Instructions
Type of
Lubrication
Lubrication Interval
Accutrol (sweep unload)
bottom shaft bearing. Lubricate slowly until lube
shows through seal.
Wipe clean. High quality, grade #2
lithium based grease. Beginning of season (annually).
Blower motor bearings. See motor lubrication
procedure
below .
High quality, grade #2
lithium based grease. Every 2 years (Normal
operation, ever 8-10 months
continuous operation).
Metering variable speed
drive motor. See motor lubrication
procedure
below .
High quality, grade #2
lithium based grease. Every 2 years (Normal
operation, ever 8-10 months
continuous operation).
Accutrol sweep gearbox. Grease filled gearbox.
Additional grease does not
need to be added.
¹Lubrication of motors - Operate motor for 20 minutes. Clean grease fitting. Remove grease relief plug and using a
low pressure grease gun, pump in the required grease. After re-lubricating, allow motor to run for 10 minutes before
replacing relief hardware. DO NOT over grease.