Grain Systems PNEG-1820 - Manual (Page 27)

PNEG-1820 CE Compliant Top Dry Series 2000 Autoflow 27
11. Pre-Season Checks
Before the dryer is filled, inspect the unit and check the operation of the dryer as follows. Never enter a
bin where grain is present.
Set Control Switches
• Moisture Control switch - “ON”
• Aeration Fan switch - “OFF”
• Load Auger switch - “OFF”
• Fan switch - “OFF”
• Heater switch - “OFF”
• Dump switch - “AUTO”
• Dry and Hold switch - “OFF”
• Autoflow Emergency Stop switch - “OUT”
• Actuator switch - “ON”
• Fill System Control Box Emergency Stop switch - “OUT”
Control Power Switch
Turn the control power switch ON. The switch will illuminate. If a fault is found an error message will be
displayed on the screen. If all are found safe, the main drying screen will be displayed.
Figure 11A Top Dry Component Placement