Grain Systems PNEG-584 - Manual (Page 21)

21
SERIES TWO HEATER
CONFIGURATION DIP
SWITCHES (NORMALLY
DONE AT FACTORY)
Stand alone heater
with no slaves, all
dip switches in the
off state.
These switches are used to config-
ure the heater control for various
types of heaters.
Multiple heaters connected together through the serial link.
Master with one
slave-dip switch 7
on/all others off.
Slave #1-dip switch
one on/all others
off.
Master with two
slaves-dip switch 8
on/all others off.
Slave #2-dip switch
two on/all others
off.
Master with 3
slaves-dip switch 7
& 8 on/all others
off.
Slave #3-dip switch
one & two on/all
others off.
The backside of the control board, showing the dip switch placement.
FACTORY CONFIGURATION