Grain Systems PNEG-349 - Manual (Page 6)

6
Service Platform & Stiffener PLATFORM INSTALLATION
Airstream service platform units are
designed for use with Airstream two
and three module grain dryers. The
two module models require a service
platform on the upper module, and
the three module units use a platform
on both the upper and center mod-
ules.
For ease of assembly, the plat-
form should be fully installed before
the module is lifted and installed.
Install the platform support
channels and related parts within the
platform package number one as fol-
lows:
1. If required, connect a platform
attachment bracket, D61-0054,
onto each side of the dryer as
shown. Using the existing large
bolts through the round set of
bracket holes.
Loosely connect the two
rear anchor channels, D61-0055,
to the platform attach brackets us-
ing 3/8" x 1" bolts with washers.
2. Remove hitch tongue from the
dryer, and support the front end
of the dryer under the frame side
rails.
Loosely connect the main
support channel, D01-2033, to
the front end of the dryer hitch
weldment. Use four 1/2" x
1-1/2" bolts with washers on slot
ted side. The channel side with
the large round holes must be
up.
Platform Support
Channels
Figure 1, Right:
Connecting rear
anchor chan-
nels. Figure 2,
Below: Mount-
ing the main
support channel.