Grain Systems PNEG-349 - Manual (Page 17)

17
Service Platform & Stiffener PLATFORM INSTALLATION
Platform Guard Rails
Use 5/16" x 3/4" bolts and install plat-
form guard rails within platform pack-
age # 4. Guard rails should be installed
so that the smooth rail surfaces and
bolt heads are within the compartment
to provide maximum body protection
from corners and angle edges.
1. Connect the upper side guard
rail onto each side.
2. Connect the upper front guard rail.
3. Connect two rear guard rails
onto each rear side of platform.
4. Connect two lower front guard rails.
5. Connect the lower front side
guard rail, and the lower rear
side guard rail onto each side
platform. Connect the access
door clip on the left side of the
platform.
6. Fully tighten all guard rail bolts,
including the seven guard rail
support channels not tightened
earlier.
Figure 22, top: Installing front and
side upper guard rails. Figure 23,
above: Installing lower side guard
rails. Figure 24, right: Installing
lower rear guard rail.