Grain Systems PNEG-349 - Manual (Page 11)

11
Service Platform & Stiffener PLATFORM INSTALLATION
Install the floor support angles
as follows:
1. Use two flathead allen capscrews
and connect the left floor sup-
port angle, D01-2030, to the
rear angle tie and main sup-
port channel.
2. Connect the rear access door
support, D01-2037, frame be
tween the support angle and the
left-hand side channel.
3. Install the front access door
support frame, D01-2036, to
the side frame and front left-
hand floor support. Use the 5/
16" whiz bolts and nuts to bolt it in
place.
4. The forward frame goes under the
top edge of the side channel and
over the front left-hand floor sup-
port.
Figure 11: Installing forward frame on the access door.
Floor Support Angles
Figure 12: Close-up of forward and rear door frame installation.
D01-2036
D01-2037
D01-2030