Grain Systems PNEG-349 - Manual (Page 18)

18
Service Platform & Stiffener PLATFORM INSTALLATION
Figure 25, right: Installing access
door. Figure 26, below: Make sure
door opens freely and lies on frame
angles.
Access Door
Install the platform access door and
related parts as follows:
1. Install access door in place with
the hinge ends located outward.
2. Use two 3/8" x 1-1/2" bolts as
hinge pins and install them with
the heads positioned inward.
3. Secure each hinge pin in place
by installing nuts on each side
of the outer channel leg. Adjust
the position of the hinge pins,
as necessary, to center the
door properly. Tighten nuts se-
curely to lock pins in place.
Inspect the completed service plat-
form unit. Make sure all parts are
properly installed and fully tight-
ened.