Grain Systems PNEG-1283 - Manual (Page 9)

4. Installation
PNEG-1283 Moisture Sampler 9
10. Now put the Moisture Sampler assembly up to the discharge box again and put in the 5/16" bolts
and nuts and tighten just enough to firmly hold Moisture Sampler in place. Use a marker and mark
the four (4) holes at the sensor end of the assembly as shown in
Figure 4E . Also mark the square
hole inside the sample tube as shown in Figure 4E .
Figure 4E
11. Remove the Moisture Sampler again and drill the four (4) bolt holes at the sensor end with a 3/8"
drill bit and cut out the square hole marked out in Step 10 .
Mark and drill holes with a
5/16" drill bit
Mark and cut square hole