Grain Systems PNEG-1283 - Manual (Page 11)

4. Installation
PNEG-1283 Moisture Sampler 11
Figure 4G
18. Install sheave (018-1047-2) and bushing (D32-0016) on the bottom auger shaft that extends
through the discharge box. The key that comes with the bushing is not needed for this installation.
Slide bushing into the sheave (leave loose, do not force the bushing in). Slide sheave and bushing
onto the auger shaft. Insert bushing bolts through the non-threaded holes of the bushing (threaded
holes are for bushing removal) and thread into the holes of the sheave. Tighten bolts evenly until
bushing is snug against the auger shaft but still loose enough to slide on auger shaft so that its
position can be adjusted in a later step.
Figure 4H
Auger shaft
Flangette
Bearing
Discharge box
bearing plate
Lock collar