beautypg.com

Flashing instructions (optional), Chapter 14 flashing instructions (optional) – Grain Systems Tanks PNEG-603 User Manual

Page 48

background image

48

PNEG-603 4" Commercial Hopper Tank

14. Flashing Instructions (Optional)

1. Attach flashing to the bin wall using the pre-punched holes at 8" above the horizontal seam.

2. Attach left side of the first piece of flashing to the sidewall using the connection as shown

in Figure 14A

. Working clockwise, overlap the flashing at the right hand hole of each piece of

flashing. NOTE: If bolts are installed at flashing seam location they will need to be removed.

3. At vertical seams attach flashing that is to span the vertical seams using both left and right holes.

Drill flashing holes from the outside of the bin through the sidewall sheet holes. Remove drilled
flashing and assemble vertical seam bolts and nuts.

(See Figure 14C on Page 49.)

Replace drilled

flashing and attach according to

Figure 14B

. Continue around the bin clockwise.

Figure 14A Flashing Hardware

Figure 14B Vertical Seam Flashing Hardware