Grain Systems Tanks PNEG-603 - Manual (Page 30)

7. Hardware
30 PNEG-603 4" Commercial Hopper Tank
** For stiffener to sidewall quantities, see stiffener hardware on Page 29 .
Bolting Requirements 2 Stiffeners per Sidewall Sheet
All bolts are standard bin bolts with neoprene washers. For horizontal and vertical seam bolts, the bolt
head and neoprene washers are on the outside of the bin.
* NOTE: For the splice plates FC-42076 and 12 gauge and thicker stiffener overlaps use 5/16" x 1-1/4"
bolts for the stiffener to sidewall connections.
Figure 7A Standard Sheet Bolting Detail (Viewed from Outside of the Bin)
FCHT Sidewall Hardware **
Refer to Stiffener Sheets for Stiffener
to Sidewall Hardware Usage.
20 Gauge to 15 Gauge
56 S-275 5/16" x 3/4" Bin Bolt
56 S-396 5/16" Hex Nuts
7 S-4458 Caulking (24' Roll)
14 Gauge
68 S-275 5/16" x 3/4" Bin Bolt
68 S-396 5/16" Hex Nuts
7 S-4458 Caulking (24' Roll)
Sidewall
Gauge
Horizontal
Seam *
Vertical
Seam
Stiffener to
Sidewall **
Overlap
Seam
15 through 20
5/16" x 3/4"
[10]
5/16" x 3/4"
[42]
5/16" x 3/4"
[20]
5/16" x 3/4"
[2]
14
5/16" x 3/4"
[22]
5/16" x 3/4"
[42]
5/16" x 3/4"
[20]
5/16" x 3/4"
[2]
10 through 13
3/8" x 1"
[22]
3/8" x 1"
[42]
5/16" x 1-1/4"
[20]
5/16" x 1-1/4"
[2]