Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Speed Control- Banks Exhaust Brake '03-early 04 - Manual (Page 13)

9 7 0 5 3 v 8 . 0
| 13
main brake cylinder. see Figure
8. Find the PINk wire with
Gray stripe and install a t-tap.
Note: It may require removing the
factory electrical tape. Locate the
BLaCk Banks brake wire that has
an OraNGE wire emerging from
the bottom of its convolute. Install
this Banks Brake BLaCk wire
into this t-tap.
30.
Locate the antilock Brake
Controller next to the battery on
the driver side. see Figure 9.
Find the Dark GrEEN wire
with yELLOW stripe entering
the connector that is closest to the
battery. Install a t-tap on the wire.
Find the Banks Brake OraNGE
wire that emerges from the
BLaCk wire convolute (the same
one mentioned in Step 29). Plug
the OraNGE wire into the t-tap.
31
. Locate the BrOWN Banks
Brake wires on the harness. Insert
the 16” extension wires onto each
terminal. Find the C131 connector
in the engine compartment. It is
the purple and gray connector
near the master brake cylinder.
see Figure 8. Locate the VIOLEt
wire with yELLOW stripe. Cut
the wire and crimp a female spade
connector on one end of the cut
wires and a male spade connector
on the other end. (It does not
matter which connector goes on
which wire.) Connect the two
BrOWN Banks wires into these
spade connectors. secure the
BrOWN wires with the supplied
cable ties.
32.
route the Banks Brake
Gray and BLuE wires behind
the battery box on the driver side
Figure 12
Figure 11
Figure 13