Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Interface- Banks iQ 2.0 Ford(03-10), Chevy(01-10), Dodge(03-07) User Manual

Page 14

96834 v.1.0

NOTE: Banks iQ will only display Banks
Power Tuner, SpeedBrake, or other
Banks software functions if you have
purchased them. Remember, you can
upgrade your Banks iQ as new software
is developed and learn more about other
Banks iQ applications anytime. Register

at www.bankspower.com/banksiq to

receive important e-mail alerts regarding

updates and upgrades for your Banks

iQ device. Or call us with questions at
1-800-GET POWER.
Turn the Banks iQ on by pressing and
holding the ‘Power’ button on top
of Banks iQ. Start-up will take a few
seconds while the Banks iQ scans to see
if Banks Power Tuner and/or SpeedBrake
are enabled. After initial start-up, Banks
iQ will display the ‘Mode Select’ Menu.
See Figure 8 & 9. To navigate through
the menu press the left or the right
arrows. The Banks iQ will display the
options available for your vehicle.
If a Banks Power Tuner and a
SpeedBrake are installed, both can be
controlled in one Mode Screen. If only
a Banks Power Tuner or a SpeedBrake
is installed, select the Mode to control

that specific device. After a selection has
been made, the Banks iQ will start in the
selected Mode Screen. To access other
applications, press the ‘Banks iQ Home’
icon at any time in the lower left hand
side to return to the Mode Select Menu.
See Figure 10.
Sleep Mode
When Banks iQ is connected to your

vehicle it will go into ‘Sleep Mode’

whenever the vehicle is turned off.
NOTE: For some vehicle models,

Banks Power Tuners will stay on for

approximately one minute after the

vehicle is shut off. The iQ will turn off

after the Power Tuner turns off.

For some vehicle models, If in the

Navigation Mode, the iQ may require to

be put into sleep mode manually.

There is no need to exit the Banks iQ

application or to turn the iQ off. Banks

iQ will automatically ‘Wake Up’ when

the vehicle ignition is turned on or the

‘Power’ button is pressed.
When Banks iQ is disconnected from

the vehicle or power supply, the iQ will

go into ‘Sleep Mode’ if no activity is

Section 4

SOFTWaRE INTRODUCTION

Figure 7 Start up