Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ - Manual (Page 20)

20
96814 v.2.0
4.
Locate the Banks MAF sensor
o-ring supplied in your kit. Install
Banks o-ring as shown in Figure 27.
Ensure o-ring is flush to MAF sensor
edge as shown.
Note: Retain stock o-ring. Keep stock
o-ring in place, you will be installing
the Banks o-ring while retaining the
original o-ring on the MAF sensor.
5.
Locate your Banks Ram-Air intake
tube in your kit. Install the stock MAF
sensor (with the additional Banks
o-ring) to MAF sensor mounting
boss as shown in Figure 28. Tighten
screws to 3 in/lbs.
Note: Ensure correct alignment as
shown otherwise screw holes will not
align with screw holes in the Banks
Ram-Air intake tube.
Caution: Do NoT oVER TIGHTEN
SCREWS
6.
Locate the Banks compressor
inlet hose and hose clamps from
your Banks Ram-Air kit. Loosely fit
the hose clamp onto your Banks inlet
hose. Install the Banks inlet hose
and hose clamp and tighten it to the
compressor inlet.
7.
Install Banks Ram-Air intake tube
to Banks inlet hose and hose clamp.
Lightly tighten the hose clamp. Note:
leave the clamps snug to allow
movement of the inlet hose to allow
correct alignment.
8.
Locate the previously removed
stock air box and remove the stock
air filter Minder. Make sure to remove
the stock air filter Minder rubber
grommet as well. See Figure 29.
9.
Locate the Banks Ram-Air filter
housing cover. Install the previously
removed air filter minder rubber
grommet into the Banks Ram-Air
filter housing cover. Once rubber
grommet is installed flush into the
Banks Ram-Air cover, then locate the
previously removed air filter minder
and install into the rubber grommet.
Make sure air filter minder is installed
flush to rubber grommet.
Figure 27
Figure 28
Figure 29