Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (iQ) Compatible with Optional Banks iQ User Manual

Page 19

96814 v.2.0

RAM-AIR INSTALLATIoN
Use the Bill of Materials Chart and

the General Assembly Drawing to

reference component nomenclature

and location. See Figure 23. Use

caution when working in the engine

compartment. Make sure the engine

has been OFF for several hours and

cool. Make sure to complete

Steps 1 thru 3 of Section 2 before

proceeding.
2001 thru 2004 LB7 Duramax engine

You will have either a decorative

cover or a resonator covering the

intake manifold. The decorative cover

may need to be removed in order to

facilitate installation and alignment

of the Banks Ram-air intake system.

Remove the decorative cover by

removing the screw securing the

rubber grommet. Once the rubbe

grommet is removed, lift up and

unhinge the decorative cover from

its mount. Reinstall decorative cover

after the installation of the Banks

Ram-air system is complete. See

Figure 24.
If you have the resonator with

attached decorative cover then the

resonator and attached decorative

cover will be removed from the

engine and will not be used in

conjunction with the Banks Ram-Air

intake system. See Figure 25.

Locate your Banks Ram-Air filter

housing from your kit and install as

shown in Figure 26. The cutout on

Banks Ram-Air filter housing must

face passenger side fender. Align

the Banks Ram-Air filter housing

holes with bolt holes in engine

compartment. Install the previously

removed stock air box bolts to

secure the Banks Ram-Air filter

housing. Do not tighten the bolts at

this time.

Locate your Banks Torx tool,T20H

in your Banks Ram-Air kit. Use the

Torx tool bit to remove the two (2)

screws securing the MAF sensor to

the stock air box cover.
Note: When removing the MAF

sensor, grasp its body and pull up

and out. Do not twist or bend when

removing.

Figure 26

Figure 25

Figure 24