beautypg.com

Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only User Manual

Page 28

background image

Section 7:

REMOvAL OF THE SIx-GUN DIESEL TUNER

1.

If the Six-Gun Diesel Tuner should

ever need to be removed from the

vehicle, perform the following:

1.) Disconnect the Six-Gun’s 46-pin

connector (connector c) from the

middle connection on the PcM.
2.) Re-connect the vehicle’s 46-pin

connector back into the middle

connection on the PcM.
3.) Disconnect the GRAY and VIOLET

wires from the T-taps on the PcM’s

“A” and “B” connectors (the Six-

Gun’s fused power wire does not

need to be removed).
4.) Disconnect the Six-Gun’s MAP

connections from the vehicles MAP

sensor and harness. Re-connect the

vehicle’s MAP connector back into

the MAP sensor.

5.) Disconnect the 2-ring terminals

from the EGT probe.
6.) Disconnect the Six-Gun’s 12-pin

harness connector (harness “B”

shown in Figure 5).
7.) Remove the Six-Gun module.

Failure to follow the above instructions

when removing the module will result

in a “check Engine” light on the dash

and a Diagnostic Trouble code being

stored in the factory computer, in

addition to the engine not running.

-EnD, SECTIon 7-

Gale Banks Engineering
546 Duggan Avenue • Azusa, cA 91702
(626) 969-9600 • Fax (626) 334-1743

Product Information & Sales: (888) 635-4565
customer Support: (888) 839-5600
Installation Support: (888) 839-2700
bankspower.com