Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only - Manual (Page 23)

96450 v.9.0
23
10.
Reconnect the exhaust
backpressure static line tube.
11.
Connect the sensor wire to the Six-
Gun module with the supplied screws.
The yellow sensor wire attaches to the
free yellow wire on the Six-Gun module.
The red sensor wire attaches to the free
red wire on the Six-Gun module.
12.
Slide the heat shrink over the
exposed metal junction, and supply
moderate heat to seal the connection.
A heat gun works well.
13.
Route the pyrometer to the exhaust
manifold and install the DynaFact
pyrometer probe in the fitting.
-EnD, SECTIon 3-
Figure 17 Location to drill and tap the driver side exhaust manifold for
the DynaFact pyrometer sensor
Figure 18 Exhaust manifold
tightening sequence
Figure 19 Turbocharger
adapter pipe torque specification