beautypg.com

Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch User Manual

Page 9

background image

96448 v.12.0

9

SECTION 1

SIx-GUN DIESEL TUNER INSTaLLaTION

For 2003 vehicles, start from Step 1.

For 2004 vehicles, start from Step 2.

1.

FOR 2003 VEHIcLES ONLY: Locate

the large black connector (c130) on

the driver side between the battery

and the firewall. See Figure 1. Remove

the two (2) plastic screws on the

sides of the connector and move the

connector aside. Retain the two (2)

screws and the two (2) retainers for

re-installation.

2.

Locate the rubber grommet on the

drivers side firewall. Using a utility

knife, make a 1.5-inch-long slit in the

grommet next to the wire harness.

Be careful not to cut or damage

the harness. See Figure 2 for the

proper location of the required cut.

Insert a screwdriver from the engine

compartment into the cut hole and

thrust it through the grommet.

3.

Inside the vehicle, remove the

lower dash panel beneath the steering

column by removing the two (2)

screws at the bottom of the panel.

Retain the screws for re-installation.

Figure 1

Figure 2

See also other documents in the category Banks Power For the car: