Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 30)

30
96448 v.12.0
1.
After confirming the functionality
of the system, make sure the entire
mounting surface is clean and free of
dirt and oil before mounting the Six-
Gun Diesel Tuner. clean and dry as
required using a cloth dampened with
rubbing alcohol or similar cleaning
solution.
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result.
Mount the Six-Gun Diesel Tuner on
the back of the lower dash panel as
shown in Figure 22 by peeling off the
protective backing off the adhesive tape
on the back of the Six-Gun Diesel Tuner
box.
Note: the Six-Gun Diesel tuner may
not clear the steering structure if it is
mounted differently.
2.
Hold the module against the
panel for approximately 1 minute
while applying pressure to allow the
adhesive to properly adhere to the
surface.
3.
Re-install the electric connector
bracket that was removed in Step 4
below the steering column in the front
of the fire wall with the original two (2)
bolts.
4.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure
the wiring under the dash. Secure all
wiring under the hood away from heat
sources or sharp edges. Re-install the
lower dash panel with the original 2
bolts. Your Banks product installation
is complete.
-END, SEcTION 7-
SECTION 7
MOUNTING THE SIx-GUN MODULE
Figure 22