Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-04 For use with Six-Gun Switch - Manual (Page 6)

6
96448 v.12.0
The Banks Six-Gun Diesel Tuner has
six power levels adjustable by the
supplied Six-Gun switch.
Level 1 is stock . Each additional
higher level adds approximately 20%
of the available power increase.
To prevent damage to the factory
transmission, Banks recommends
that both automatic and manual
transmission vehicles do not exceed
Level 4 while the vehicle is experiencing
load (towing, climbing a steep grade,
carrying a load, etc.).
To use the higher levels of the Six-Gun
Diesel Tuner while towing or climbing,
airflow improvements must be made
to lower the exhaust gas temperature
(EGT) entering the turbo. The EGT
should not exceed 1350º F for more
than a few seconds. Elevated EGT
can damage the turbocharger and the
engine.
Also, the factory clutch or torque
converter will need to be upgraded to
an aftermarket unit that can handle
the increased torque and horsepower
of the higher levels. Failure to upgrade
the clutch or torque converter prior
to using the upper levels while the
vehicle is loaded may result in damage
to the factory clutch or torque.
Banks is NOT responsible for clutch,
torque converter and/or transmission
damage.
Note: Before proceeding with these
instructions, please carefully read
the DISCLAIMeR oF LIABILItY and
LIMItAtIoN oF WARRANtY statement
located on page 4 of this manual.
1.
For ease of installation of your
Banks Six-Gun, familiarize yourself
with the procedures by reading the
entire manual before starting work.
2.
Disconnect the ground cable from
the battery before beginning work. If
there are two batteries, disconnect
both.
3.
Route and tie wires and hoses
a minimum of 6 inches away from
exhaust heat, moving parts and sharp
edges. clearance of 8 inches or more
is recommended where possible.
4.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides; put the transmission in
park; set the hand brake; and place
blocks behind the rear wheels.
CAUTION! Do not use floor jacks to
support the vehicle while working
under it. Do not raise the vehicle
onto concrete blocks, masonry
or any other item not intended
specifically for this use.
5.
The installation should be
performed at a time when the vehicle
has been allowed to completely cool.
This installation requires the installer
to work near surfaces that may remain
hot after the vehicle has been run.
General Installation Practices
Dear Customer,
If you have any questions
concerning the installation
of your Banks Six-Gun Diesel
Tuner, please call our Technical
Service Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at
(888) 839-5600.
Thank you.