Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA User Manual
Page 42
If the Banks EconoMind Diesel Tuner
has been moved to a different
vehicle, or you are instructed to
do so by Banks Technical Staff,
it is possible to reset all of the
parameters that the EconoMind has
‘learned’.
CAuTIoN: The following
procedures can only be carried
out with the engine oFF!
1.
Turn the vehicle key to ON but Do
NoT start the engine.
2.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times. The GREEN LED
will flash when this is completed
successfully.
3.
Turn the key OFF. Wait 30
seconds, or until the GREEN LED goes
off and stays off. Turn the key back
to the ON position but Do NoT start
the engine.
4.
Fully depress the throttle pedal
and then release it completely.
Repeat 5 times
-END, SEcTION 11-
The Banks PowerPDA is designed
such that new software updates
can be easily installed. check the
BanksPower web site at www.bankspower.com/downloads> for the latest version of the Banks PowerPDA software. Once you have determined that your Banks Power- PDA should be updated, follow the instructions on the page for the ap- propriate software update. The Banks EconoMind Diesel Tuner is designed such that new firmware updates can be easily installed. check the BanksPower web site at www.bankspower.com/downloads> for the latest version of the Banks EconoMind Diesel Tuner firmware. Once you have determined that your Banks EconoMind Diesel Tuner should be updated, follow the instructions on the page for the appropriate firmware update. END, SEcTION 12- If the Banks EconoMind Diesel Tuner should ever need to be removed from the vehicle, perform the following: 1. Disconnect the EconoMind’s 38-pin connector from the factory harness. 2. Re-connect the vehicle’s 38-pin connector back into the factory harness. 3. Disconnect the EconoMind’s 24-pin connector from the factory harness. 4. Re-connect the vehicle’s 24-pin connector back into the factory harness. 5. Disconnect the 2-ring terminals from the EGT thermocouple. 6. Disconnect the 3 small connectors on the ‘In-cab cable’ and gently pull the cable back through the firewall. 7. Remove the Banks EconoMind Diesel Tuner. instructions when removing the module will result in a “Check Engine” light on the dash and a Diagnostic Trouble Code being stored in the factory computer, in addition to the engine not running. -END, SEcTION 13- Section 13 REMoVAL oF THE ECoNoMIND DIESEL TuNER Section 11 CLEARING LEARNED PARAMETERS Section 12 uPDATING youR BANkS PoWERPDA SoFTWARE & BANkS ECoNoMIND DIESEL TuNER FIRMWARE 42 96776 v.11.0
Note: Failure to follow the above