beautypg.com

Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA User Manual

Page 26

background image

RAM-AIR INSTALLATIoN
Use the Bill of Materials chart and

the General Assembly Drawing to

reference component nomenclature

and location. See Figure 24. Use

caution when working in the engine

compartment. Make sure the engine

has been OFF for several hours and

cool. Make sure to complete

Steps 1 thru 3 of Section 2 before

proceeding.
2001 thru 2004 LB7 Duramax engine

1.

You will have either a decorative

cover or a resonator covering the

intake manifold. The decorative cover

may need to be removed in order to

facilitate installation and alignment

of the Banks Ram-air intake system.

Remove the decorative cover by

removing the screw securing the

rubber grommet. Once the rubbe

grommet is removed, lift up and

unhinge the decorative cover from

its mount. Reinstall decorative cover

after the installation of the Banks

Ram-air system is complete. See

Figure 25
If you have the resonator with

attached decorative cover then th

resonator and attached decorative

cover will be removed from the

engine and will not be used in

conjunction with the Banks Ram-Air

intake system. See Figure 26.

Figure 26

Figure 25

26

96776 v.11.0

See also other documents in the category Banks Power For the car: