Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA - Manual (Page 28)

5.
Locate your Banks Ram-Air intake
tube in your kit. Install the stock MAF
sensor (with the additional Banks
o-ring) to MAF sensor mounting
boss as shown in Figure 29. Tighten
screws to 3 in/lbs.
Note: Ensure correct alignment as
shown otherwise screw holes will not
align with screw holes in the Banks
Ram-Air intake tube.
Caution: Do NoT oVER TIGHTEN
SCREWS
6.
Locate the Banks compressor
inlet hose and hose clamps from
your Banks Ram-Air kit. Loosely fit
the hose clamp onto your Banks inlet
hose. Install the Banks inlet hose
and hose clamp and tighten it to the
compressor inlet.
7.
Install Banks Ram-Air intake tube
to Banks inlet hose and hose clamp.
Lightly tighten the hose clamp. Note:
leave the clamps snug to allow
movement of the inlet hose to allow
correct alignment.
8.
Locate the previously removed
stock air box and remove the stock
air filter Minder. Make sure to remove
the stock air filter Minder rubber
grommet as well. See Figure 30.
Figure 29
Figure 30
28
96776 v.11.0