Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Power Systems- PowerPack & Stinger Systems w_ EconoMind (LB7 & LLY) '01-05 (PDA) Compatible w_ Optional PowerPDA - Manual (Page 32)

3.
Locate the two black wire harness
locking connectors between the
brake fluid reservoir and the air
conditioning compressor. Lift the gray
connector locks and disconnect the
38-pin connector pair and the 24-pin
connector pair (see Figure 38).
4.
Insert the male 38-pin connector
on the EconoMind harness into the
female 38-pin connector on the
factory harness. Insert the female
38-pin connector on the EconoMind
harness onto the male 38-pin
connector of the factory harness.
Repeat this process with the 24-pin
connectors (see Figure 38).
5.
connect the thermocouple
leadwire to the EconoMind harness
with the supplied nuts and bolts.
cover this joint with the supplied
heat shrink tubing and heat until the
tubing conforms to the joint. Make
sure the entire joint is insulated.
MouNTING THE BANkS
ECoNoMIND DIESEL TuNER
6.
The EconoMind is to be installed
under the hood on the outside of
the fuse box, with the wire harness
facing towards the rear of the vehicle
(see Figure 39). Make sure the
outside of the fuse box is free of oil,
grease and dirt.
7.
With the Banks EconoMind Diesel
Tuner positioned next to the fuse
box, peel the protective backing
from the hook and loop interlocking
fasteners attached to the Banks
EconoMind Diesel Tuner. Position the
bottom edge of the Banks EconoMind
Diesel Tuner approximately a half
inch above the main wiring harness
exiting the fuse box, then press the
adhesive onto the outside of the
fuse box. Apply light pressure to
the Banks EconoMind Diesel Tuner
by hand for 60- seconds to create
a strong bond between the fuse
box and hook & loop interlocking
fasteners. Using the supplied cable
ties, secure the wire harness away
from any heat sources or moving
components.
-END, SEcTION 5-
Figure 39 Driver’s side of engine compartment
Figure 38
32
96776 v.11.0