Rough Country 720.20 - Manual (Page 2)

FRONT INSTALLATION INSTRUCTIONS
1. Lift the front of the vehicle using a jack and support the vehicle with jack stands, so that the front wheels are off the ground
2. Remove the front tires/wheels., using a 21mm deep well socket
3. Loosen the (3) nuts on top of the strut using an 18mm wrench as shown in Photo 1. Do not remove nuts completely.
4. Remove lower strut bolts using a 15mm wrench as shown in photo 2.
5. Remove them bolt clips from the strut as shown in Photo 3.
6. Use disc sander on the front right corner relative to the front of vehicle and grind corner off bar pin to fit as shown in Photo 4.
7. Position the strut to bottom of the control arm. Using the provided 1/4” spacer, place between control arm and bar pin as shown
in photo 5. Flat side of plate will face the inside of vehicle as shown.
8. Using the provided 7/16” grade 9 bolts, nuts and washers install as shown in Photo 6. Using a 5/8” & 11/16”, torque 60 ft/lbs.
9. Retighten upper strut bolts to correct torque spec with 18mm wrench. Install the wheels / tires, using a 21mm deep well socket.
Repeat steps 3-9 on Driver Side.
10. Jack up the vehicle and remove the jack stands. Lower the vehicle to the floor and torque all bolts to factory specifications.
PHOTO 2
*ONLY USE PROVIDED 7/16 GRADE 9 BOLTS*
DO NOT REPLACE
PHOTO 1
PHOTO 3 PHOTO 4
PHOTO 5 PHOTO 6