Rough Country 1043 - Manual (Page 2)

Thank you for purchasing a Rough Country Suspension Component.
4. Cut the canister bracket off as shown in Photo 3 from the frame rail using a reciprocating saw or cut off wheel. The
edges can be ground down and black paint is recommended to prevent rusting. Photo 4 shows the bracket re-
moved.
5. For Install on the winch plate: Install the bracket on the frame with the supplied 1/2” x 3/4” bolt, flat washer be-
tween the bracket & frame as a spacer & flat flag nut. The 1/2” x 3/4” bolt / flag nut included with the winch plate will
be used in the lower location. See Photo 5.
6. For Install on winch bumper: Install the bracket on the frame with the supplied 1/2” x 3/4” bolt, flat washer in the
lower hole between the bracket & frame as a spacer & flat flag nut on the lower mount. See Photo 6.
7. The upper hole will be secured with the 1/2” hardware included with the winch bumper. See Photo 7.
8. Install the hoses, wiring harness and couplings on the canister and tighten the hardware using a 10mm socket /
wrench. See Photo 8.
PHOTO 3 PHOTO 4
PHOTO 5
PHOTO 7
POST INSTALLATION INSTRUCTIONS
• All hardware must be checked periodically to ensure all fasteners are tight.
CUT THE BRACKET FROM THE FRAME
PHOTO 6
PHOTO 8