Rough Country 1101 - Manual

2” WHEEL SPACER KIT INSTRUCTIONS FOR
6-5.5” & 8-6.5” WHEEL PATTERNS
Thank you for choosing Rough Country for all your suspension needs.
Professional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. At-
tempts to install these wheel spacers without this knowledge and expertise may jeopardize the integrity and/or operating
safety of the vehicle.
Please read instructions before beginning installation. Also please review tools needed list and
make sure you have needed tools.
Important Note: Spacers must be periodically checked to ensure tightness.
Kit Contents:
Part #1101 2-2” Wheel Spacers (6 LUG)
Part #1095 2-2” Wheel Spacers (8LUG)
92110100
Tools Needed:
Torque Wrench Floor Jack
Jack Stands Sockets
Socket wrench
INSTALLATION INSTRUCTIONS
1. Chock the tires and jack up the vehicle.
2. Remove the lug nuts and remove the tire and wheel. If retain-
ing clips are present they must be removed for the spacer to
sit flat on the rotor surface. Note: Failure to remove the
factory retaining clips on the wheel studs could result in
a wheel /tire vibration.
3. Install the wheel spacers as shown with the supplied lug nuts.
See Photo 1. Tighten to manufacturer specifications using a
19mm wrench. DO NOT EXCEED MANUFACTURER
SPECIFICATIONS.
4. Reinstall the tires/wheels on the wheel spacers.
5. Tighten the lug nuts holding the wheels and tires to factory
specifications.
Post Installation
• Spacers must be re-torqued periodically. Visually inspect components and re torque fasteners during rou-
tine vehicle service.
Photo 1
#1095 2” THICK 8-6.5” PATTERN WHEEL SPACER
# 1101 2” THICK 6-5.5” PATTERN WHEEL SPACER