Rough Country 375 - Manual

Rough Country recommends this system be installed by a certified technician. In addition to these instructions, profes-
sional knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to
install this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehi-
cle.
Please read instructions before beginning installation. Check the kit hardware against the Kit Contents List. Be sure you
have all needed parts and know where they go.
PRODUCT USE INFORMATION
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands is not recommended. Rough Country will not be responsi-
ble for any product that is altered.
If question exist, please call us @1-800-222-7023. We will be happy to answer any questions concerning the design,
function, and correct use of our products.
2013 Dodge 3500 2.5” Leveling Kit
Tools Needed:
10mm Socket
13mm Socket
21mm Wrench / Socket
9/16” Socket
7/8” Socket
92375000
INSTALLATION INSTRUCTIONS
1. Chock the rear wheels. Jack up the front of the vehicle and place jack stands directly behind the lower control arm
mounts on the frame rails. After the vehicle is on jack stands, position a floor jack underneath the front differential.
This is to support the axle and to allow the front axle to droop to remove the stock coil springs. Remove the tires and
wheels with a 7/8” socket.
2. Remove the sway bar link with a 10mm socket and a
21mm wrench. See Photo 1.
3. Remove the lower shock bolt using a 21mm socket. Note
this bolt has a flag nut. Retain hardware for reuse.
4. Remove the push pin wire tie from the box on the axle for
movement to remove the coil.
5. Remove the brake line from the mount on top of the ra-
dius arm using a 13mm socket.
Kit Contents:
2– Coil Spring Spacers
1-375bag:
2-3/8” x 3 1/4” Bolts
2-3/8” Flat Washer
2-Flag Nuts
Photo 1