Rough Country 8595 - Manual

02-10 HD TORSION ADJUSTERS
W/SHOCK BRACKETS
92859500
Thank you for choosing Rough Country for your suspension needs.
Rough Country recommends a certified technician install this system. In addition to these instructions, professional
knowledge of disassemble/reassembly procedures as well as post installation checks must be known. Attempts to install
this system without this knowledge and expertise may jeopardize the integrity and/or operating safety of the vehicle.
PRODUCT USE INFORMATION
As a general rule, the taller a vehicle is, the easier it will roll. Offset, as much as possible, what is lost in rollover
resistance by increasing tire track width. In other words, go "wide" as you go "tall".
Do not add, alter, or fabricate any factory or after-market parts to increase vehicle height over the intended height of the
Rough Country product purchased. Mixing component brands, lifts, and/or combining body lift with suspension lifts voids
all warranties. Rough Country makes no claims regarding lifting devices and excludes any and all implied claims. We will
not be responsible for any product that is altered.
Braking performance and capability are decreased when significantly larger/heavier tires and wheels are used. Take this
into consideration while driving.
The required installation time for this system is approximately 2 hours. This suspension system was developed using
285x75R16 tire on an 8” wheel. Before installing other combinations, please consult your local tire and wheel specialist.
A front-end alignment should ALWAYS be checked after installing ANY vehicle suspension lift. This kit typically requires
a slight toe-in adjustment. Record the ride height measurement at the time of alignment. If, in the future the torsion bars
settle excessively, alignment can be restored by adjusting-up the bars to their original ride height.
If questions exist on the design, function, and correct use of our products please contact us at 800-222-7023.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the
vehicle of its unique handling characteristics.
RECOMMENDED TOOLS
• Floor jack
• Heavy duty jack stands
• Safety glasses
• Wheel chocks
• Ball Joint Remover like
OTC7249
• Impact gun
• 18 mm socket
• 15 mm socket
• 21 mm socket