Rough Country 1151 - Manual (Page 2)

POST INSTALLATION
• All components must be retightened after 500 miles, and checked periodically after installation.
Thank You for using Rough Country for your off road vehicle needs
4. Using the bracket as a guide, center the bracket and drill directly above the lower hole using a 5/16” bit. See
Photo 5.
5. Install the supplied flag nut as shown in Photo 6 with the supplied 5/16” x 3/4” bolt and washer. Tighten using a
1/2” wrench.
6. On the driver side, measure back 5 1/2” from fire wall to center of the u-bolts as shown and install the u-bolt
clamp and bracket. See Photo 7. Tighten clamps using a 9/16” wrench.
7. Install the studs in the bracket as shown in Photo 8 with the supplied 5/16” lock nut and tighten using a 1/2”
wrench.
8. On the passenger side, measure back 6 3/4” from fire wall to center of the u-bolts as shown and install the u-bolt
clamp and bracket. See Photo 9.
9. Install the mounting stud with the supplied 5/16” lock nut and tighten using a 1/2” wrench.
10. Install the shock struts on the mounting studs as shown in Photo 10. Adjust mounting studs as necessary to
even lift on Jeep hood.
Photo 5 Photo 6
Photo 7 Photo 8
Photo 9 Photo10
DRILL USING BRACKET AS A GUIDE INSTALL USING SUPPLED FLAG NUT
INSTALL DRIVER LOWER BRACKET INSTALL MOUNTING STUDS
INSTALL PASSENGER LOWER BRACKET INSTALL SHOCK STRUTS