Rough Country 1118 User Manual
Jeep jk front 4”track rod bracket
92111800
Thank you for choosing Rough Country for your suspension needs.
Please read instructions before beginning installation. Check the kit hardware against the parts list. Be sure you have all
needed parts and know where they go. Also please review tools needed list and make sure you have needed tools.
NOTICE TO DEALER AND VEHICLE OWNER
Any vehicle equipped with any Rough Country product should have a “Warning to Driver” decal installed on the inside of
the windshield or on the vehicle’s dash. The decal should act as a constant reminder for whoever is operating the vehi-
cle of its unique handling characteristics.
JEEP JK FRONT 4”TRACK ROD BRACKET
Installation Instructions
1. Remove the stock stabilizer and bracket from the axle mount using a 18mm wrench See Photo 1.
2. Install the track rod bracket as shown on the stock mount. See Photo 2.
3. Install the crush sleeve with the stock hardware as shown in Photo 3. Do not tighten at this time.
4. Install the supplied u-bolt and nuts in the bracket as shown in Photo 4. Do not tighten at this time.
PHOTO 1
PHOTO 2
REMOVE STOCK STABILIZER
INSTALL CRUSH SLEEVE
PHOTO 3
PHOTO 4
INSTALL STOCK HARDWARE
INSTALL U-BOLT