Rough Country 1166 - Manual (Page 2)

7. Install the stock track rod in the lower hole of the new track
rod bracket with the stock hardware. See Photo 3. It may be
necessary to pull the axle over to the passenger side to align
the hole in the bracket with the track rod bushing.
8. Tighten all hardware using a 3/4”, 21mm & 22mm sockets/
wrench.
9. Jack up the rear of the vehicle and remove the jack stands.
10. Lower vehicle to the ground.
MAINTENANCE INFORMATION
It is the ultimate buyers responsibility to have all bolts/nuts checked for tightness after the first 500 miles and then every
1000 miles. Wheel alignment steering system, suspension and driveline systems must be inspected by a qualified pro-
fessional mechanic at least every 3000 miles.
Photo 3
Thank you for purchasing a Rough Country Suspension Component.