Rough Country 795 - Manual (Page 2)

PHOTO 2
1. Make sure vehicle is off and in park before beginning. Lift vehicle for easy access or may be completed on the ground using
wheel chokes to prevent movement.
2. Using a 18mm socket, remove the stock skid plate shown in Photo 1.
3. Remove the 2 bolts in the front of the gas tank skid plate using an 18mm as shown in Photo 2.
4. Remove the bolt from the side of the frame using 18mm.
5. Remove the bolt from the inside of the of the gas tank pocket using an 18mm. Photo 3.
6. Place new RC skid in place as shown in Photo 4 & 5 and install the 2 bolts in the front of the skid plate as well as the stock bolt
in the outer frame mount (Photo 6) with an 18mm wrench.
7. Using the front skid plate bracket (the one with the smallest hole in it ) reinstall the stock bolt in the bracket. Do not tighten.
8. Install the (2) 90500362 bolts and the (2) 81046 washers in the skid plate mount as shown tightening the 7/16 bolts, Then con-
tinue to tighten the 18mm stock bolt. Photo 7 and 8.
9. Continue on each bracket repeating above steps.
PHOTO 5 PHOTO 6
PHOTO 1
PHOTO 3 PHOTO 4